Bookmark and Share




Saturday, February 20, 2010

Open Question: removing pressed board and two layers of floor. nails are in pressed board. Is there a machine to help? and more...

 
 



Open Question: removing pressed board and two layers of floor. nails are in pressed board. Is there a machine to help? and more...

Open Question: removing pressed board and two layers of floor. nails are in pressed board. Is there a machine to help?

Lots of nails are in the pressed board that was put over old floor so new could be put in. Now want to remove all...is there a managable machine for this?

Email to a friendRelated



Open Question: Extension ring for 4" x 2" welded "handy box"?

I ended up putting a layer of 1/2" OSB before the drywall on a wall to allow the secure installation of shelves, but now that I have everything ready to to install the outlets I realize that the box is a half inch too far back into the wall. There are two 4"x2" welded handy boxes in this wall that I need to add some sort of extension to, however the only handy box extensions I have seen are 1-1/2" or 1-7/8" deep. Does any know any other options?

Email to a friendRelated



Open Question: Can I seam felt backed vinyl flooring in a kitchen?

I've got a sheet vinyl roll that has a soft padding on the back. It is ment for being used as a floating floor. With the size of my kitchen, I will need to seam it in the middle of the room. Can I seam this product, and if I can, do I seam it with glue, double sided tape, a seaming compound?

Email to a friendRelated



Open Question: How to take a broken pencil out of a pencil sharpener?

Well i had a really thick pencil, that i tried to fit it in to my sharpener. It got stuck, and while i was trying to pull it out, the pencil broke :\, and now theirs a half pencil stuck in the sharpener , Help? and i can't take the emptying container out, because the pencil is also stuck their :\

Email to a friendRelated



Open Question: How can I get memory wire to not bend?

I have a project to do and I'm using memory wire for it. The problem is that when I try to make it into a bigger circle, it bends into a taco shape. How do I prevent this from happening?

Email to a friendRelated



Open Question: How to clean the top part of an apply? I am talking about the part where the apply gets connected to the roots?

of the tree. After you buy it, you take off a small part on the top and try washing it. That part is not easy to get to to clean. Is there a way to clean it?

Email to a friendRelated



Open Question: Suggestions for converting a barn to casual home? Ad for 1440 square ft barn, cement floor/2story for $15000?

Am trying to figure most reasonable route to putting a cabin on land. Unsure if it would be cheaper to go with cabin same size, standard built or have this barn built with idea of making it a cabin and doing some work myself. Cement floor raises ? on leaving as is or should build up a floor. Any suggestions/ideas are welcomed. Thanks!

Email to a friendRelated



Open Question: Attach carpet to wire?

In my rats cage i am looking to cover some wire balconies with carpet, any ideas on how to do this? Thanks!

Email to a friendRelated



More Recent Articles


Click here to safely unsubscribe now from "Yahoo! Answers: Search for " or change your subscription or subscribe

Your requested content delivery powered by FeedBlitz, LLC, 9 Thoreau Way, Sudbury, MA 01776, USA. +1.978.776.9498

 

0 comments: